| Internet-Draft | Evpn Mpls Ping Extension | November 2022 |
| Dikshit, et al. | Expires 24 May 2023 | [Page] |
In an EVPN or any other VPN deployment, there is an urgent need to tailor the reachability checks of the client nodes via off-box tools which can be triggered from a remote Overlay end-point or a centralized controller. There is also a ease of operability needed when the knowledge known is partial or incomplete. This document aims to address the limitation in current standards for doing so and provides solution which can be made standards in future. As an additional requirement, in network border routers, there are liaison/dummy VRFs created to leak routes from one network/fabric to another. There are scenarios wherein an explicit reachability check for these type of VRFs is not possible with existing mpls-ping mechanisms. This draft intends to address this as well. Few of missing pieces are equally applicable to the native lsp ping as well.¶
This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.¶
Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at https://datatracker.ietf.org/drafts/current/.¶
Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."¶
This Internet-Draft will expire on 24 May 2023.¶
Copyright (c) 2022 IETF Trust and the persons identified as the document authors. All rights reserved.¶
This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (https://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Revised BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Revised BSD License.¶
VTEP: Virtual Tunnel End Point or Vxlan Tunnel End Point¶
RD: Route Distinguisher¶
RT: Route Target¶
LSP: Label Switched Path¶
LER: Label Edge Router¶
LSR: Label Switch Router¶
NLRI: Network Layer Reachability Information¶
EVPN: Etherenet Virtual Private Network¶
In an EVPN or any other VPN deployment, there is an urgent need to tailor the reachability checks of the client nodes via off-box tools which can be triggered from a remote Overlay end-point or a centralized controller and also customize check if the knowledge known is partial or incomplete. This document aims to address the limitation in current standards for doing so and provides solution which can be made standards in future. As an additional requirement, in network border routers, there are liaison/dummy VRFs created to leak routes from one network/fabric to another. There are scenarios wherein an explicit reachability check for these type of VRFs is not possible with existing mpls-ping mechanisms. This draft intends to address this as well.¶
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in [RFC2119].¶
When used in lowercase, these words convey their typical use in common language, and they are not to be interpreted as described in [RFC2119].¶
This document intends to solve multiple problems, all related to ease of serviceability, troubleshooting and provisioning. In a nut shell, the solution eases out the network management of overlay network with MPLS fabric for network operators and end-users. the following subsections detail out the problems at hand.¶
For overlays like EVPN, where the NLRI key is complex to remember; the OAM ping (access) to a NLRI, may be difficult to achieve by providing the exact prefix key. For example, an EVPN NLRI index consists of list of following parameters, which typically are combined to be treated as long string index, comprising of, Route Type, RD, Ethernet Segment Index (ESI), Ethernet-Tag, IP-prefix, MAC-IP. Instead it will be easier, if the administrator remembers few or significant of the above information and remaining can be sent as wild-card or dont care values. For example, the OAM trigger for LSP-ping for a host 10.10.10.1 to a remote tunnel endpoint referred by IP address 1.1.1.1, can be initiated a combination of Route-Distinguisher, Ethernet Segment Index and Ethernet tag as wild card values, thus simplifying the OAM procedures.¶
The complex string problem is generic in nature and is applicable to other attributes like FEC, thus making this enhancement useful for underlay mpls ping as well.¶
The complex string is similar to FEC carried in the ping packet. For example, RSVP IPv4 FEC carries attributes to complete the traffic engineering tuple index. While remembering the complete information may not be trivial for the operator. Hence partial information like Tunnel-ID and Destination IP address may be significant ones which can achieve the same check.¶
The current set of OAM standards are built around validating the co-relation of control plane and dataplane information. For example, set of same-prefixes which are published by more than two external border routers, only one of them may make it to the Routing table of other routers (receiving these routes).¶
As mentioned above, the choice of validating control plane and dataplane for an NLRI ping is not in place in the EVPN( or any Overlay) OAM specifications [I-D.draft-ietf-bess-evpn-lsp-ping]. When the routing data is huge, and the control plane protocol are in the middle of churn, it is difficult to ascertain if the remote network in remote site is in steady state or not. An overlay ping is should help validate only the data plane and forgo any control plane validation, so that the control plane churn is not adding to the CPU cycles for the routing or OAM entities like processes and daemons running on the remote vteps.¶
To extend this problem state further, when admin access to vtep (in a non-local operator domain) is not possible, control plane information can be obtained by leveraging the control plane options only. Thus providing a side-view of the protocol rib on the remote device.¶
This problem is also generic in nature and not restricted to EVPN or any other VPN NLRI per-se. Hence equally applicable to underlay or transport LSPs.¶
In a typical VPN deployments between branch offices, or a Datacenter deployment in an enterprise, be it MPLS or Vxlan fabric, the border routers of the fabric cater to terminating or relaying of multi-tenancy across fabric. That is, border routers are provisioned with routing and/or bridging-domains for clients while also extending it beyond the geography or site. The border routers are provisioned with stitching of inter-site tunnels/Overlays.¶
To simplify configuration and provisioning of overlays, a dedicated VRF is created to ensure all routes learnt from external network (from various client VRFs) over, lets say, BGP-MPLS L3VPN peering, can be de-multiplexed or leaked into a single VRF which is leveraged as a dedicated VRF for learnings from external network. This VRF is used by the intra fabric constructs as a client VRF. For example, in a Vxlan fabric, this is vrf is one of the tenant VRFs which a rightful mapping to EVPN constructs like EVI( for example VNI). This client VRF does not require any interface configuration, as the purpose of this VRF is to act as a liaison for the external routes.¶
Since there is no ip address( layer 3 interface) configured on this VRF, its not possible to check the state of the VRF on the border router via OAM methods. The state of VRF can be defined as following¶
If there is no route leaked into the VRF, the BR will not form a tunnel with any other Vtep in the site. Hence an OAM check to reach out to the VRF will not work even though the VRF is up and working.¶
The EVPN extension for MPLS OAM is being driven by [I-D.draft-ietf-bess-evpn-lsp-ping], and does not resolves the problem mentioned above.¶
This document proposes a three new TLVs which an Overlay OAM PDU like mpls ping, that can carry to fill up the gap with the rightful or optimal information to the remote tunnel end points¶
These PDUs are described for an MPLS EVPN fabric, but can be generalized for any EVPN fabric per se¶
The Wild Card Tlv addresses the problem described in section Section 4.1.¶
For example, if an OAM ping to a prefix does not requires any RD (Route-Distinguisher) validation, then RD value, to be carried in IP prefix TLV; can be indicated as wild-card (dont care).¶
The following diagram shows the wild-card list TLV and the following table, describe the fields, followed by the receive side processing¶
0 1 2 3 4
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Type | Length | Sub-TLV Type |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Bits corresponding to fields in Sub-TLV |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
Field | Description
============================================================
Type | Type field can be newly defined as a proprietary one.
|
Length | length of the TLV
|
Sub-TLV Type | Sub-TLV type value as defined in draft-ietf-bess-evpn-lsp-ping
|
Bitmap | Maps to field(s) inside Sub-TLV. The bit-map indicates which field(s)
| in the Sub-TLV type is carried as wild card.
NOTE: The bitmap for fields is very specific to the sub-tlv. The assumption is that there are no more than 32 unique fields carried in mpls ping packet across all sub tlvs. For example, in [I-D.draft-ietf-bess-evpn-lsp-ping], if for a EVPN MAC Sub-TLV, the RD is to set as wild card, then the Sub-TLV-Type carries a value 2 as defined in [RFC7432] and bitmap has 1st bit set indicating the 1st field of the TLV is RD.¶
If the receiving BGP peer does not supports the wild-card list TLV,¶
If the receiving BGP peer support wild-card-list TLV but does not supports the wild-card ignorance of the field for validating the OAM request¶
if the receiving BPG peer supports wild-card list TLV, then,¶
The validation Scope TLV addresses the problem mentioned in section Section 4.2.¶
The validation types are defined as follows¶
The following diagram shows the wild-card list TLV and the following table, describe the fields¶
0 1 2 3 4
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Type | Length | Validation Type |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
Field | Description
======================================================================
Type | Type field can be newly defined as a proprietary one.
|
Length | Length of the TLV
|
Validation type | Three values for the validation as of now:
| 0 Both Control plane and Dataplane Validation (DEFAULT)
| 1 Only Control plane Validation
| 2 Only Data plane Validation
If the receiving BGP peer does not supports the Validation TLV,¶
If receiving side supports Validation TLV and all its modes, it performs the validation only in the requested mode:¶
The EVI Sub Tlv addresses the issues mentioned in the section Section 4.3.¶
This solution proposes a new Object/TLV which carries the EVI (Virtual Network Identifier) information, thus ensuring that following tools and/or action-sets can be supported:¶
Ping to check VRF configuration (mapped to an EVI) on remote Vtep,¶
Ping to check VRF configuration (mapped to an EVI) on remote Vtep,¶
The EVI values carried in the EVI Sub TLV can be user-defined or derived from underlaying fabric idenfier for the EVI.¶
0 1 2 3 4
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Type | Length | EVI Identifier |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| EVI Identifier (continued) |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
Type: 1 Octet: Type field can be newly defined as a proprietary one.
Length: 1 Octet: Defines the length of the Value field.
Value: 6 Octets: EVI identifier.
This TLV aligns generically with any Overlay OAM-ping, agnostic to a fabric used in the deployment (Vxlan, MPLS, GUE, Geneve, GPE). This TLV can be integrated into OAM tools of any underlying fabric. For example, the EVI identifier for MPLS will be 4-octets. Hence length field will carry '4' as the length.¶
NOTE: Nil FEC described in [RFC8029], can also be leveraged for the ping when the underneath fabric is MPLS.¶
Backward Compatibility for non-support nodes is as per the following standards already defined in [RFC7606], that, BGP speaker should discard the unsupported TLV types¶
This document inherits all the security considerations discussed in [I-D.draft-ietf-bess-evpn-lsp-ping].¶
This document inherits all the IANA considerations discussed in [I-D.draft-ietf-bess-evpn-lsp-ping].¶