| Internet-Draft | P2MP Policy Ping | March 2023 |
| Bidgoli, et al. | Expires 10 September 2023 | [Page] |
SR P2MP policies are set of policies that enable architecture for P2MP service delivery. A P2MP Policy consists of candidate paths that connects the Root of the Tree to a set of Leaves. The P2MP policy is composed of replication segments. A replication segment is a forwarding instruction for a candidate path which is downloaded to the Root, transit nodes and the leaves.¶
This document describes a simple and efficient mechanism that can be used to detect data plane failures in P2MP Policy Candidate Paths (CPs) and Path Instances (PIs).¶
This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.¶
Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at https://datatracker.ietf.org/drafts/current/.¶
Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."¶
This Internet-Draft will expire on 10 September 2023.¶
Copyright (c) 2023 IETF Trust and the persons identified as the document authors. All rights reserved.¶
This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (https://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Revised BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Revised BSD License.¶
Each P2MP Policy can have multiple Candidate Paths (CP)s. The CP with highest preference is the active CP while all other CPs are the backup CPs. A CP can have multiple PIs to allow global optimization of the CP via Make Before Break procedures between the active PI and the newly setup and optimized PI.¶
It is desirable to test the end to end connectivity of a CP, whether it is the active CP or a backup CP and all the CP's PIs. This document describes a mechanism that can be used to detect data plane failures in P2MP Policy CP and its associate Path Instances (PI).¶
This draft is only for replication SIDs that use MPLS encap for their forwarding and not SRv6. It reuses most of the concepts in [RFC6425]¶
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in BCP 14 [RFC2119] [RFC8174] when, and only when, they appear in all capitals, as shown here.¶
A P2MP Policy and its corresponding Replication Segments are usually setup via a controller, the root and the leaves are discovered as per [draft-ietf-pim-sr-p2mp-policy]. The tree is calculated from the root to the leaves. There is no underlay protocol to signal the P2MP Policy from the root to the Leaf routers, as such when a P2MP tree fails to deliver user traffic, the failure can be difficult to pin point without a ping/traceroute mechanism to isolate the fault in the P2MP tree. The P2MP Policy ping/traceroute can be utilize to detect faults on the path of the tree and its associated replication segments [draft-ietf-spring-segment-routing-policy-13]. These tools can be used to periodically ping the leaves to ensure connectivity. If the ping fails, trace route can be initiated to determine where the failure lies. The ping/traceroute can be initiated from the node that initiates the P2MP policy.¶
Ping/Traceroute packets are forwarded on the P2MP Policy, on a specific CP or its active PI toward the leaf routers. They are replicated at the replication point based on the replication segment forwarding information on the corresponding node. This draft only addresses the replication segments that use MPLS encap only, future drafts will address the SRv6 forwarding. The packet are processed accordingly when their TTL expires or when the egress router (leaf) is reached. The appropriate respond is send back to the root as per procedures in [RFC6425]¶
This draft reuses most procedures for mLDP in RFC [RFC6425]¶
This draft also reuses the same destination UDP port as [RFC8029]¶
The implementation should take into account that there can be many CPs under the P2MP Policy and the implementation should allow each CP and its corresponding PI to be tested via Ping and Trace route. The Ping and Traceroute packet is forwarded via that specific CP and its corresponding replication segments. On the egress node the corresponding CP and its PI should respond irrespective if it is the active CP or a backup CP.¶
Two replication segments can be connected via a unicast SR domain. In this scenario the SR tunnel labels need to be programmed with the right TTL depending on the which type of hierarchical MPLS TTL mode is used. As an example pipe vs uniform mode. When in SR domain the P2MP Tree PING and Traceroute will be processed on the two connecting replication segments based on the replication SID and its TTL. As such the SR domain will act as a single hop on the replication SID and the replication SID TTL is subtracted by one before the unicast SR SIDs are pushed on the replication SID. To detect failure in SR domain is beyond the scope of this draft.¶
The packet format used is as per [RFC8029] section 3. Some new TLVs and sub-TLVs are required to support the new functionality. They are described in the following sections.¶
[RFC8029] defines a simple and efficient mechanism to detect data-plane failures in Multiprotocol Label Switching (MPLS) Label Switched Paths (LSPs). In order to identify the correct replication segment for the CP and its PI, the echo request message MUST carry an Identifier TLV for the Candidate path and the Path instance that is under test. This draft defines a new sub-TLV: a P2MP policy MPLS Candidate Path sub-TLV. The new sub-TLV is assigned Sub-Type identifiers (TBD), and is described in the following sections.¶
artwork
Sub-Type Length Value Field
-------- ------ -----------
TBD xx P2MP Policy MPLS Candidate Path
¶
The format of the P2MP Policy MPLS Candidate Path sub-TLV value field is specified in the following figure. The value fields are taken from the definitions of the P2MP Policy section 3 of [draft-ietf-pim-sr-p2mp-policy]¶
artwork
0 1 2 3
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Address Family | Address Length| Reserved |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| |
~ Root Address ~
| |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Tree-ID |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Instance-ID |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
¶
As per [RFC6425] section 3.2 Four sub-TLVs are used for the inclusion in the P2MP Responder Identifier TLV carried on the echo request message.¶
The Sub-TLVs for IPv4 and IPv6 egress address P2MP responder is in par with [RFC6425] section 3.2.1¶
The Sub-TLVs for IPv4 and IPv6 node address P2MP responder is in par with [RFC6425] section 3.2.2¶
IANA is requested to assign sub-type values to the following sub-TLVs under TLV type 1 (Target FEC Stack) from the "Multi-Protocol Label Switching (MPLS) Label Switched Paths (LSPs) Ping Parameters" registry, "TLVs and sub-TLVs" sub-registry. This sub-type value should be assigned from the standards Action of range 0-16383 for TLV type 1 (Target FEC Stack)¶
TBD: P2MP Policy MPLS Candidate Path¶
TBD¶