| Internet-Draft | IP Proxying Requirements | January 2021 |
| Chernyakhovsky, et al. | Expires 12 July 2021 | [Page] |
There is interest among MASQUE working group participants in designing a protocol that can proxy IP traffic over HTTP. This document describes the set of requirements for such a protocol.¶
Discussion of this work is encouraged to happen on the MASQUE IETF mailing list masque@ietf.org or on the GitHub repository which contains the draft: https://github.com/ietf-wg-masque/draft-ietf-masque-ip-proxy-reqs.¶
This note is to be removed before publishing as an RFC.¶
Source for this draft and an issue tracker can be found at https://github.com/ietf-wg-masque/draft-ietf-masque-ip-proxy-reqs.¶
This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.¶
Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at https://datatracker.ietf.org/drafts/current/.¶
Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."¶
This Internet-Draft will expire on 12 July 2021.¶
Copyright (c) 2021 IETF Trust and the persons identified as the document authors. All rights reserved.¶
This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (https://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License.¶
There exist several IETF standards for proxying IP in a way that is authenticated and confidential, such as IKEv2/IPsec [IKEV2]. However, those are distinguishable from common Internet traffic and often blocked. Additionally, large server deployments have expressed interest in using a VPN solution that leverages existing security protocols such as QUIC [QUIC] or TLS [TLS] to avoid adding another protocol to their security posture.¶
This document describes the set of requirements for a protocol that can proxy IP traffic over HTTP. The requirements outlined below are similar to the considerations made in designing the CONNECT-UDP method [CONNECT-UDP], additionally including IP-specific requirements, such as a means of negotiating the routes that should be advertised on either end of the connection.¶
Discussion of this work is encouraged to happen on the MASQUE IETF mailing list masque@ietf.org or on the GitHub repository which contains the draft: https://github.com/ietf-wg-masque/draft-ietf-masque-ip-proxy-reqs.¶
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in BCP 14 [RFC2119] [RFC8174] when, and only when, they appear in all capitals, as shown here.¶
There are multiple reasons to deploy an IP proxying protocol. This section discusses some examples of use cases that MUST be supported by the protocol. Note that while the protocol needs to support these use cases, the protocol elements that allow them may be optional.¶
Consumer VPNs refer to network applications that allow a user to hide some properties of their traffic from some network observers. In particular, it can hide the identity of servers the client is connecting to from the client's network provider, and can hide the client's IP address (and derived geographical information) from the servers they are communicating with. Note that this hidden information is now available to the VPN service provider, so is only beneficial for clients who trust the VPN service provider more than other entities.¶
Point-to-point connectivity creates a private, encrypted and authenticated network between two IP addresses. This is useful, for example, with container networking to provide a virtual (overlay) network with addressing separate from the physical transport. An example of this is Wireguard.¶
Point-to-Network connectivity is the more traditional remote-access "VPN" use case, frequently used when a user needs to connect to a different network (such as an enterprise network) for access to resources that are not exposed to the public Internet.¶
Network-to-Network connectivity is also called a site-to-site VPN. Similar to the point-to-network use case, the goal is to connect two networks that are not exposed publicly. The site-to-site aspects make this transparent to the user; the entire networks are connected to each other and route packets transparently without a VPN client installed on the user's device. This style of connectivity can also be used to connect devices that cannot run VPN clients through to the network.¶
This section lists requirements for a protocol that can proxy IP over an HTTP connection.¶
The protocol will allow the client to request establishment of an IP Session, along with configuration options and one or more associated Data Transports. The server will have the ability to accept or deny the client's request.¶
The protocol will establish Data Transports, which will be able to forward IP packets. The Data Transports MUST be able to forward packets in their unmodified entirety, although extensions may enable the use of modified packet formats (e.g., compression). The protocol will support both IPv6 [IPV6] and IPv4 [IPV4].¶
The protocol will allow endpoints to inform each other of the Maximum Transmission Unit (MTU) they are willing to forward. This will allow avoiding IP fragmentation, especially as IPv6 does not allow IP fragmentation by nodes along the path.¶
The client will be able to request to be assigned an IP address range, optionally specifying a preferred range. In response to that request, the server will either assign a range of its choosing to the client, or decline the request. For symmetry, the server may request assignment of an IP address range from the client, and the client will either assign a range or decline the request.¶
At any point in an IP Session (not limited to its initial negotiation), the protocol will allow both client and server to inform its peer that it can route a set of IP prefixes. Both endpoints can also request a route to a given prefix, and the peer can choose to provide that route or not.¶
Note that if an endpoint provides its peer with a route, the peer is in no way obligated to route its traffic through the endpoint.¶
When negotiating the creation of an IP Session, the protocol will allow both endpoints to exchange an identifier. As examples, the identity could be a user name, an email address, a token, or a fully-qualified domain name. Note that this requirement does not cover authenticating the identifier.¶
The protocol MUST be run over a protocol that provides mutual authentication, confidentiality and integrity. Using QUIC or TLS would meet this requirement.¶
The protocol will allow the ability to proxy IP packets without flow control, at least when HTTP/3 is in use. QUIC DATAGRAM frames are not flow controlled and would meet this requirement. The document defining the protocol will provide guidance on how best to use flow control to improve IP Session performance.¶
A passive network observer not participating in the encrypted connection should not be able to distinguish IP proxying from regular encrypted HTTP Web traffic by only observing non-encrypted parts of the traffic. Specifically, any data sent unencrypted (such as headers, or parts of the handshake) should look like the same unencrypted data that would be present for Web traffic. Traffic analysis is out of scope for this requirement.¶
The IP proxying protocol discussed in this document will run over HTTP. The protocol SHOULD strongly prefer to use HTTP/3 [H3] and SHOULD use the QUIC DATAGRAM frames [DGRAM] when available to improve performance. The protocol SHOULD also support HTTP/2 [H2] as a fallback when UDP is blocked on the network path. Proxying IP over HTTP/2 MAY result in lower performance than over HTTP/3.¶
Since recent HTTP versions support concurrently running multiple requests over the same connection, the protocol SHOULD support multiple independent instances of IP proxying over a given HTTP connection.¶
The protocol will provide a mechanism by which clients and servers can add extension information to the exchange that establishes the IP Session. If the solution uses an HTTP request and response, this could be accomplished using HTTP headers.¶
Once the IP Session is established, the protocol will provide a mechanism that allows reliably exchanging extension messages in both directions at any point in the lifetime of the IP Session.¶
The subsections below list possible extensions that designers of the protocol will keep in mind to ensure it will be possible to design such extensions.¶
This extension would allow for load balancing of the traffic sent across the IP Session, such as to another server. This allows the IP proxying mechanisms to scale-out to multiple servers.¶
Since the protocol will offer a way to convey identity, extensions will allow authenticating that identity, from both the client and server, during the establishment of the IP Session. For example, an extension could allow a client to offer an OAuth Access Token [OAUTH] when requesting an IP Session. As another example, another extension could allow an endpoint to demonstrate knowledge of a cryptographic secret.¶
While it is desirable to transmit IP packets unreliably in most cases, an extension could provide a mechanism to allow forwarding some packets reliably. For example, when using HTTP/3, this can be accomplished by allowing Data Transports to run over both DATAGRAM and STREAM frames.¶
An extension will allow exchanging congestion and flow control parameters to improve performance. For example, an extension could disable congestion control for non-retransmitted Data Transports if it knows that the proxied traffic is itself congestion-controlled.¶
While the core protocol Data Transports will transmit IP packets in their unmodified entirety, an extension can allow compressing these packets.¶
This section discusses topics that are explicitly out of scope for the IP Proxying protocol. These topics MAY be handled by implementers or future extensions.¶
This document only describes the requirements for a protocol that allows IP proxying. It does not discuss how the IPs assigned are determined, managed, or translated. While these details are important for producing a functional system, they do not need to be handled by the protocol beyond the ability to convey those assignments.¶
Similarly, "ownership" of an IP range is out of scope. If an endpoint communicates to its peer that it can allocate addresses from a range, or route traffic to a range, the peer has no obligation to trust that information. Whether or not to trust this information is left to individual implementations and deployments.¶
Some servers may wish to perform Network Address Translation (NAT) or any other modification to packets they forward. Doing so is out of scope for the proxying protocol. In particular, the ability to discover the presence of a NAT, negotiate NAT bindings, or check connectivity through a NAT is explicitly out of scope and left to future extensions.¶
Servers that do not perform NAT will commonly forward packets similarly to how a traditional IP router would, but the specific of that are considered out of scope. In particular, decrementing the Hop Limit (or TTL) field of the IP header is out of scope for MASQUE and expected to be performed by a router behind the MASQUE server, or collocated with it.¶
How packets are forwarded between the IP proxying connection and the physical network is out of scope. For example, this can be accomplished on some operating systems using a TUN interface. How this is done is deliberately not specified and will be left to individual implementations.¶
This document only discusses requirements on a protocol that allows IP proxying. That protocol will need to document its security considerations.¶
This document requests no actions from IANA.¶
The authors would like to thank participants of the MASQUE working group for their feedback.¶