The ORIGIN Extension in HTTP/3

Status of This Memo

This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.¶

Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at https://datatracker.ietf.org/drafts/current/.¶

Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."¶

This Internet-Draft will expire on 8 April 2023.¶

Copyright Notice

Copyright (c) 2022 IETF Trust and the persons identified as the document authors. All rights reserved.¶

This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (https://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Revised BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Revised BSD License.¶

Table of Contents

1. Introduction

Existing RFCs define extensions to HTTP/2 [HTTP2] which remain useful in HTTP/3. Appendix A.2.3 of [HTTP3] describes the required updates for HTTP/2 frames to be used with HTTP/3.¶

[ORIGIN] defines the HTTP/2 ORIGIN frame, which indicates what origins are available on a given connection. It defines a single HTTP/2 frame type.¶

2. The ORIGIN HTTP/3 Frame

The ORIGIN HTTP/3 frame allows a server to indicate what origin(s) ([RFC6454]) the server would like the client to consider as members of the Origin Set (Section 2.3 of [ORIGIN]) for the connection within which it occurs.¶

The semantics of the frame payload are identical to those of the HTTP/2 frame defined in [ORIGIN]. Where HTTP/2 reserves Stream 0 for frames related to the state of the connection, HTTP/3 defines a pair of unidirectional streams called "control streams" for this purpose. Where [ORIGIN] indicates that the ORIGIN frame should be sent on Stream 0, this should be interpreted to mean the HTTP/3 control stream. The ORIGIN frame is sent from servers to clients on the server's control stream.¶

HTTP/3 Origin-Entry {
  Origin-Len (16),
  ASCII-Origin (..),
}

HTTP/3 ORIGIN Frame {
  Type (i) = 0x0c,
  Length (i),
  Origin-Entry (..) ...,
}

3. Security Considerations

This document introduces no new security considerations beyond those discussed in [ORIGIN] and [HTTP3].¶

4. IANA Considerations

This document registers a frame type in the "HTTP/3 Frame Type" registry ([HTTP3]).¶

Author's Address