Bootstrapping WebSockets with HTTP/3

Status of This Memo

This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.¶

Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at https://datatracker.ietf.org/drafts/current/.¶

Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."¶

This Internet-Draft will expire on 18 June 2022.¶

Copyright Notice

Copyright (c) 2021 IETF Trust and the persons identified as the document authors. All rights reserved.¶

This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (https://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Revised BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Revised BSD License.¶

Table of Contents

1. Introduction

[RFC8441] defines an extension to HTTP/2 which is also useful in HTTP/3. This extension makes use of an HTTP/2 setting. Appendix A.3 of [HTTP3] describes the required updates for HTTP/2 settings to be used with HTTP/3.¶

2. Conventions and Definitions

The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in BCP 14 [RFC2119] [RFC8174] when, and only when, they appear in all capitals, as shown here.¶

3. Websockets Upgrade over HTTP/3

[RFC8441] defines a mechanism for running the WebSocket Protocol [RFC6455] over a single stream of an HTTP/2 connection. It defines an Extended CONNECT method which specifies a new ":protocol" pseudo header field and new semantics for the ":path" and ":authority" pseudo header fields. It also defines a new HTTP/2 setting sent by a server to allow the client to use Extended CONNECT.¶

The HTTP/3 stream closure is also analogous to the TCP connection closure of [RFC6455]. Orderly TCP-level closures are represented as a FIN bit on the stream (Section 4.2 of [HTTP3]). RST exceptions are represented with an stream error (Section 8 of [HTTP3]) of type H3_REQUEST_CANCELLED (Section 8.1 of [HTTP3]).¶

The semantics of the headers and setting are identical to those in HTTP/2 as defined [RFC8441]. Appendix A.3 of [HTTP3] requires that HTTP/3 settings be registered separately for HTTP/3. The SETTINGS_ENABLE_CONNECT_PROTOCOL value is 0x08 (decimal 8), as in HTTP/2.¶

If a server which advertises support for Extended CONNECT but receives an Extended CONNECT request with a ":protocol" value that is unknown or is not supported, the server SHOULD respond to the request with a 501 (Not Implemented) status code (Section 15.6.2 of [HTTP]). A server MAY provide more information via a Problem Details response [RFC7807].¶

4. Security Considerations

This document introduces no new security considerations beyond those discussed in [RFC8441].¶

5. IANA Considerations

This document registers a new setting in the "HTTP/3 Settings" registry ([HTTP3]).¶

Acknowledgments

TODO acknowledge.¶

Author's Address