DNS over IPv6 Best Practices

Status of This Memo

This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.¶

Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at https://datatracker.ietf.org/drafts/current/.¶

Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."¶

This Internet-Draft will expire on 4 November 2024.¶

Copyright Notice

Copyright (c) 2024 IETF Trust and the persons identified as the document authors. All rights reserved.¶

This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (https://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Revised BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Revised BSD License.¶

Table of Contents

1. Introduction

This document describes an approach to how the Domain Name Protocol (DNS) should be carried over IPv6 [RFC8200]. There have been some operatonal issues identified in carrying DNS packets over IPv6 and this draft proposes solutions to address them.¶

The IPv6 protocol requires a minimum link MTU of 1280 octets. From Section 5 "Packet Size Issues" of RFC8200:¶

• IPv6 requires that every link in the Internet have an MTU of 1280 octets or greater. This is known as the IPv6 minimum link MTU. On any link that cannot convey a 1280-octet packet in one piece, link- specific fragmentation and reassembly must be provided at a layer below IPv6.¶

Using Path MTU Discovery and IPv6 fragmentation larger packets may be sent. However, there is operational experience that seems to indicate that sending large DNS over UDP over IPv6 packets results in high loss rates.¶

Most modern transport protocols like TCP [TCP] and [QUIC] include packet segmentation techniques that allow them to send larger data streams over IPv6.¶

A recent dnsop working group document titled "IP Fragmentation Avoidance in DNS over UDP" [I-D.ietf-dnsop-avoid-fragmentation] also describes the issue, and recommends as best current practice to disable IPv6 fragmentation for sending DNS packets over IPv6. Specifically:¶

• 3.1. Recommendations for UDP responders¶
• R1. UDP responders SHOULD NOT use IPv6 fragmentation [RFC8200].¶

This document is aligned with the recommendation in [I-D.ietf-dnsop-avoid-fragmentation], but focuses on DNS over IPv6, and also recommends and provides additional details on running DNS over TCP or QUIC.¶

3. Domain Name System Protocols

The Domain Name System was originally defined in [RFC1034] and [RFC1035]. It was designed to be able to run over different transport protocols, including UDP, and TCP. It has also recently been extended to be able to run over QUIC [RFC9250]. These transport protocols can be run over IPv4 or IPv6.¶

When DNS was originally designed, the size of the DNS packets carried over UDP was limited to 512 bytes as defined in Section 2.3.4. of [RFC1035]. Longer messages were truncated and the Truncation (TC) bit was set indicating the response is incomplete so that the client can retry with TCP.¶

With this original behavior UDP over IPv6 would not exceed the IPv6 link MTU and hence would not present operational issues due to fragmentation. When DNSSEC was introduced, several responses were too small to fit into this 512 byte limit for UDP and hence resulted in TCP connections which impacted the scalability of the DNS servers. [RFC6891] allowed the requestors to specify larger UDP message sizes that they are able to handle but the sizes specified by the requestor might exceed the Path MTU.¶

4. DNS over IPv6

DNS over IPv6 is defined to run over UDP, a very simple transport protocol, or more capable transport protocols like TCP or QUIC. UDP only provides for source and destination ports, a length field, and simple checksum. It is connectionless. Transport protocols like TCP and UDP provide additional features like packet segmentation, reliability, error correction, and connection state.¶

DNS over UDP over IPv6 works fine with small packet sizes, but becomes less reliable with larger packet sizes, especially in cases that require IPv6 datagram fragmentation.¶

DNS over TCP/QUIC over IPv6 will work fine with all packet sizes. The downside of running DNS over a stateful protocol such as TCP or QUIC is that this will require more resources on the DNS server and potentially affect scalability. This might be a reasonable tradeoff in case of servers that need to send larger DNS response packets.¶

5. IANA Considerations

There are no actions required for IANA defined in this document.¶

6. Security Considerations

Switching from UDP to TCP/QUIC for large responses means that the DNS server needs to maintain additional state for each query that was received over TCP/QUIC. This will consume additional resources on the servers and impact the scalability of the DNS system. It may also leave the servers vulnerable to DoS attacks.¶

7. Acknowledgments

Geoff Huston discussed the operational issues in his article "IPv6, DNS, and truncation in UDP" IPv6" [HUSTON] and Jared Mauch brought up the issues to the 6MAN working group.¶

Helpful comments were received from Warren Kumari, and other members of the V6OPS working group.¶

8. Change log [RFC Editor: Please remove]

draft-hinden-ipv6-v6ops-00, 2024-May-02:¶

• Initial draft.¶

Authors' Addresses