| Internet-Draft | L3 LLDP MAC Address | December 2023 |
| Eastlake | Expires 27 June 2024 | [Page] |
IEEE 802 has defined a number of protocols which can operate between adjacent Ethernet stations at Layer 2, including bridges, and may be useful between Layer 3 aware stations such as IP routers and hosts. An example is the Link Layer Discover Protocol (IEEE Std 802.1AB, LLDP). This document specifies a MAC address that can be used for this purpose for interoperability despite intervening bridges.¶
This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.¶
Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at https://datatracker.ietf.org/drafts/current/.¶
Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."¶
This Internet-Draft will expire on 27 June 2024.¶
Copyright (c) 2023 IETF Trust and the persons identified as the document authors. All rights reserved.¶
This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (https://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Revised BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Revised BSD License.¶
IEEE 802 [IEEE802] has defined a number of protocols which operate between adjacent Ethernet stations at Layer 2, including bridges, such as the Link Layer Discover Protocol ([IEEE802.1AB] LLDP) and the Link Aggregation Control Protocol ([IEEE802.1AX] LACP). LLDP and other such protocols may be useful between adjacent Layer 3 [ISO] aware stations such as IP routers and hosts. This document specifies a MAC address that can be used for that purpose despite intervening bridges.¶
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in BCP 14 [RFC2119] [RFC8174] when, and only when, they appear in all capitals, as shown here.¶
In this document the terms/acronyms listed below have the indicated meaning:¶
LLDP [IEEE802.1AB] is a Layer 2 [ISO] protocol providing for the unacknowledged announcement of information by an Ethernet station to other stations on the same Ethernet link. There are proposals for the use of LLDP between L3 aware stations such as between a host and its first hop IP router or between IP adjacent routers. Examples are [LLDP1] [LLDP2] [LLDP3].¶
As illustrated in the figure below, uses of LLDP and similar protocols between Ethernet stations have a scope of adjacency controlled by the multicast destination MAC address [RFC7042bis] of the Ethernet frame used to transmit the LLDP PDU.¶
LLDP or similar Ethernet frames intended to be between adjacent IP routers or between a host and its first hop IP router need to avoid use of a destination MAC address that might be intercepted by any intervening bridge. The multicast destination MAC addresses used by bridges are the block from 0x0180C2000000 to 0x0180C200003F but it would be best to be conservative and avoid all addresses from 0x0180C2000000 to 0x0180C2FFFFFF. An address meeting this criterion is specified in Section 3 below and its use is RECOMMENDED.¶
+-------+
| Host |
+-------+
|
+---------+
|L3 Router|
+---------+
. \
. +---------------+
. |Customer Bridge|
. +---------------+
. : \
. : +---------------+
. : |Provider Bridge|
. : +---------------+
. : |
. : +---------------+
. : |Provider Bridge|
. : +---------------+
. : /
. +---------------+
. |Customer Bridge|
. +---------------+
. /
+---------+
|L3 Router|
+---------+
. \
. +---------------+
. |Customer Bridge|
. +---------------+
. /
+-------+
| Host |
+-------+
Note: The above figure is simplified. For example, where one or two customer bridges or provider bridges are shown, there could be zero or some larger number. There could also be one or more bridges between the host shown at the top of the figure and its first hop IP router. Only two levels of bridge are shown (customer and provider) but [IEEE802.1Q] specifies additional levels of bridges.¶
IANA is requested to assign a 48-bit multicast MAC address [0x00000E900004 suggested] under the IANA OUI for use with Link Layer Discovery Protocol and similar protocols between Layer 3 routers as per the request in Appendix A. The entry in the "IANA Multicast 48-bit MAC Addresses" registry is as follows:¶
Addresses Usage Reference --------- ------------------------- --------------- [tbd] Layer 3 LLDP and the like [this document]¶
(Alternatively, there could be more than on MAC address assigned for different L3 or higher layer [ISO] purposes.)¶
TBD¶
(not yet submitted)¶
Applicant Name: Donald E. Eastlake III¶
Applicant Email: d3e3e3@gmail.com¶
Applicant Telephone: +1-508-333-2270¶
Use Name: L3-LLDP¶
Document: [this document]¶
Specify whether this is an application for EUI-48 or EUI-64 identifiers: EUI-48¶
Size of Block requested: 1¶
Specify multicast, unicast, or both: multicast¶